Journal
Scientific and Technical Journal of Information Technologies, Mechanics and Optics
UDK535.421, 535.15
Issue:1 (147)
Characterization of the holographic photopolymer Bayfol HX in the IR region
Annotation
The possibility of creating holographic optical elements operating in the near infrared spectral range based on the Bayfol HX holographic photopolymer has been considered. The dynamic range of the refractive index of the photopolymer and the amplitude-phase nature of the holograms in the infrared range have been studied. The influence of recording parameters (power density of recording radiation, recording time) on the distribution of the dynamic range of the refractive index between grating harmonics has been studied. The analysis of the amplitude-phase nature of holograms was carried out by measuring the transmission spectra of the studied photopolymer after the photopolymerization reaction. The dynamic range of the refractive index of a photopolymer evaluated in the spectral range from 405 nm to 2099 nm. For this purpose, the angular selectivity contours of holograms with periods from 414 nm to 2100 nm, optimized for different parts of the specified spectral range, were measured and analyzed. The influence of recording parameters on the distribution of the dynamic range of the refractive index between the grating harmonics was analyzed by calculating the amplitudes of the first and second harmonics of the refractive index modulation from the experimentally measured angular selectivity contours of holograms recorded with different recording time at a constant irradiation dose. It was shown that the dynamic range of the refractive index of the photopolymer in the near infrared spectral range, as compared with the long-wavelength part of the visible region of the spectrum, differs by a value that does not exceed the measurement accuracy. A pronounced violation of the reciprocity was demonstrated with scaling of the interference pattern or with changing of the power density of the recording radiation. The optimal recording conditions for holograms calculated for the infrared spectral range for the studied photopolymer were found. The possibility of using of the studied holographic material in telecommunication optics has been demonstrated.
Keywords
Постоянный URL
Articles in current issue
- Study of blood vessels reaction to local heating by imaging photoplethysmography
- Transmission of 3D holographic information over a radio channel by a method close to SSB
- Anodization parameters influence on anodic aluminum oxide formed above the silver island film
- State estimation accuracy analysis of an induction electric drive by the algorithms of Luenberger and Kalman
- A method of optimizing the structure of hierarchical distributed control systems
- Method for identification of sinusoidal signal parameters with variable unknown amplitude
- Improvement of the automatic temperature stabilisation process in the cryovacuum unit
- Investigation on impact and wear behavior of Al6061 (SiC+Al2O3) and Al7075 (SiC+Al2O3) hybrid composites
- Computational methods to increase the speed of FPGA-based discrete wavelet transforms
- .Dialogue system based on spoken conversations with access to an unstructured knowledge base
- Multiobjective evolutionary discovery of equation-based analytical models for dynamical systems
- Probabilistic criteria for time-series predictability estimation
- Software framework for hyperparameters optimization of models with additive regularization
- Value-based modeling of economic decision making in conditions of unsteady environment
- Methodology for organizing and conducting a study to assess consumer ability
- Automated cluster analysis of communication strategies of educational telegram channels
- Computer modeling of non-Markovianprocesses based on the principle of balance of “complex probabilities”
- The objectification method of the weight coefficients for decision-making in multicriteria problems
- Grishentsev A.Yu., Goroshkov V.A., Chernov R.I.Assessment of the limits of applicability and methods of modulation of near-field magnetic coupling
- Numerical and analytical modeling of the propulsive wing and fuselage of an air taxi
- Using variable-precision feedback to improve operational speed of the current loop in GaN-inverters
- Simulation of diffusion processes during electrothermal treatment of reaction crucibles of the Fe-Sn system